Comment
Author: Admin | 2025-04-28
Bfgminer(1) multi-threaded multi-pool ASIC, FPGA, GPU and CPU bitcoin miner. DESCRIPTIONmulti-threaded multi-pool ASIC, FPGA, GPU and CPU bitcoin miner.Lowlevel: ftdi pci pci:uio pci:vfio spi usb vcomDrivers: antminer avalon bfx bifury bigpic bitforce bitforce:pci bitfury_gpio cairnsmore drillbit dualminer erupter gridseed hashbusteravalon hashbusterusb hashfast icarus klondike littlefury modminer opencl opencl:adl opencl:sensors proxy proxy:getwork proxy:stratum rockminer twinfury x6500 ztexAlgorithms: SHA256d scryptOptions: ncursesw5OPTIONSOptions for both config file and command line:--api-allow Allow API access only to the given list of [G:]IP[/Prefix] addresses[/subnets]--api-description Description placed in the API status header, default: BFGMiner version--api-groups API one letter groups G:cmd:cmd[,P:cmd:*...] defining the cmds a groups can use--api-listen Enable API, default: disabled--api-mcast Enable API Multicast listener, default: disabled--api-mcast-addr API Multicast listen address (default: "224.0.0.75")--api-mcast-code Code expected in the API Multicast message, don't use '-' (default: "FTW")--api-mcast-des Description appended to the API Multicast reply, default: ''--api-mcast-port API Multicast listen port (default: 4028)--api-network Allow API (if enabled) to listen on/for any address, default: only 127.0.0.1--api-port Port number of miner API (default: 4028)--balanceChange multipool strategy from failover to even share balance--benchmark Run BFGMiner in benchmark mode - produces no shares--bfl-range Use nonce range on bitforce devices if supported--chroot-dir Chroot to a directory right after startup--cmd-idle Execute a command when a device is allowed to be idle (rest or wait)--cmd-sick Execute a command when a device is declared sick--cmd-dead Execute a command when a device is declared dead--coinbase-addr Set coinbase payout address for solo mining--coinbase-sig Set coinbase signature when possible--compact Use compact display without per device statistics--debug|-D Enable debug output--debuglog Enable debug logging--device-protocol-dump
Add Comment